Vibration analysis requires a correct identification of the rotational speed of the machine. How the different frequencies of the spectrum are related to RPM, identifying with high accuracy the order of each frequency, is essential for the analysis process.
Condition-based maintenance is an important strategy used to achieve the quality and capacity that is required in manufacturing today. To achieve these goals, vibration analysis is helpful for determining rotating equipment condition and performance. Collecting correct and usable vibration data is critical to the success of any vibration analysis program. Unfortunately, there are challenges that must be overcome in order to provide this data that were not necessarily issues in the past.
- Bob Martin
- IMI Sensors
With process control systems, it’s simple (and smart) to incorporate vibration data into an existing monitoring program. Either loop-powered 4-20 mA sensors, which output a direct 4-20 mA signal, or IEPE sensors, which output dynamic data that can be converted into an acceptable process signal, can be used..
- Elise Brannon
- Wilcoxon Sensing Technologies
This webinar will be unveiling the benefits of fluid drive basics, internal configuration and the basic vibration analysis expertise required for detecting some common faults associated with the components. Live scenarios vibration data and case studies will be utilized in demonstrating the requisite knowledge required for diagnosing fluid coupling failures..
- Michael Osagada
Wherever you run the predictive maintenance program, whether in a chemical plant or in a hospital facility, there may always be tons of data filling into the databases. Therefore, it is important to visualize the quality data for the analyst in order to make the correct evaluations..
- Datong Li
- SPM Instrument AB
Overhead cranes are often a single source cause of downtime in any manufacturing facility, especially when discussing those performing services in a steel mill’s melt shop. Often, these assets do not have redundancy that would allow for one to be taken....
- Stephen Bailey
- IVC Technologies
Reliability engineers can’t be in two places at once. But when assets from two different plants are raising concern, how does the engineer figure out which one is more likely to contribute to an outage? Remote diagnostics help maintenance teams decide where to deploy valuable resources like subject matter experts, troubleshooting equipment, and spares.......
- Brett Burger
- National Instruments